Bonding Adhesive is a solvent-based contact adhesive designed specifically for bonding RubberCover EPDM membranes to approved insulation in addition to wood, metal, masonry and other acceptable substrates.

The reason why Bonding Adhesive is often used is that it is easy to lay. You can lay the EPDM straight onto it while it is still wet. 

It is also possible to correct mistakes shortly after the EPDM has been laid down up to 2-3 times if you find there is unwanted debris underneath due to it taking slightly longer than bonding to dry.

Please note: Image is for illustration purposes only.

If you would like any more information on this product, please call the number at the top of this page and speak to our super efficient sales team now!

Modular Water Based Bonding Adhesive is a water-based adhesive designed specifically for bonding RubberCover EPDM membranes to wooden surfaces and other acceptable substrates. 

Latex and neoprene water-based adhesive for bonding membrane to ply decking.

Please note: Image is for illustration purposes only.

If you would like any more information on this product, please call the number at the top of this page and speak to our super efficient sales team now!

The RubberCover edge trim is designed with its own water-check kerb to be used around the perimeter of a flat roof to direct water towards the gutter edge.

Used to finish the roof's edge where water does not drain into a gutter. This trim acts as a barrier to water at the edge of the roof. 

Permaroof Bond & Seal or Permaroof Closed Cell Foam Tape must be used to form a seal between the trim and the EPDM.

Polypins are used to fix the trim into the Fascia Board. Please see the related items below.

Please note: Image is for illustration purposes only.

If you would like any more information on this product, please call the number at the top of this page and speak to our super efficient sales team now!

This item is a two-part trim that clamps the membrane into place and creates a step into the gutter at the same time. 

The benefit of these is that they create their own seal on the roof surface, negating the need to install a timber perimeter upstand.

The Gutter backplate must be installed prior to the membrane, and the top of the plate must be flush with the deck. The EPDM will overhang approx 50mm. The front plate is then pushed under the hook of the backplate with the membrane between the two. This will then clip into place to form a smooth finish.

If you would like any more information on this product, please call the number at the top of this page and speak to our super efficient sales team now!